HolyBro Remote ID

HolyBro Remote IDWarningThis product is designed for the Standard Remote ID Solution, primarily targeting drone manufacturers and system integrators, NOT for DIY users, as you need to do your own approval process at the FAA (DoC submission) if you are in the USA. This product does not include serial number. For the most accurate and latest information related to this topic, please refer to the official governance website of your country.OverviewHolybro RemoteID Module is a low-cost, small-sized, and light-weight module that broadcasts information about UAVs in flight through WiFi and Bluetooth. It supports both CAN and serial protocols. It is an FCC and CE-approved radio module.The products run open-source firmware (ArduRemoteID) and provide a so-called standard Remote ID solution, primarily targeting drone manufacturers & system integrators. If you need customization or have a special request, feel free to reach out to us via email. SpecificationRadio module:Espressif ESP-C3 moduleBluetooth and WiFi 2.4GHz (ERP): 20 dBm (100 mW)FCC & CE certified radio moduleFirmware:ArduRemoteID (https://github.com/ArduPilot/ArduRemoteID).Supports upgrading firmware via the web interface (“OTA”)Supported in PX4 & Ardupilot (More Info)Protocol: CAN & SerialInterface:1x JST GH 4-pin CAN (CAN) port1x JST GH 6-pin TELEM (UART) portAntenna Connector type:On CNC Case: SMA connectorOn PCB: IPEX ConnectorRange: > 5km detection range*Power: 5V supplied from TELEM or CAN portLED lights: Bright RGB status LEDSize:Without case: 35.3 x 23.5 mm (not including antenna)With CNC case: 38 x 26.5 x 11.5 mm (not including antenna)Mount: M2 screwsOperating temperature: -40°C to 85°CWeight:PCB only: 4 gWith CNC case & Antenna: 27.5gWithout case & Antenna: 16.5g (Cable 20cm)Certification: FCC& CE* The detection range depends on many factors such as the receiver antenna gain, transmission protocol, weather conditions, flying height, receiver height, line of sight, etc. With professional receivers, a range of 5 km or more is possible.Guides & Reference LinksHolybro DocSetup & Configuration GuideFirmware Update GuideFirmware supportArdupilotArdupilot Wiki – RemoteIDArdupilot Wiki – OpenDroneID FW buildingPX4PX4 Guide on Remote ID/OpenDroneIDPINMAPPackage Includes：1x Remote ID1x Antenna1x JST GH 6pin 150mm Cable1x JST GH 4pin 150mm Cable